Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Remote Communication

Status
Not open for further replies.
phantompremium

phantompremium

Bioengineer
Joined
May 22, 2007
Messages
1
Location
CA
Hello everyone,

I have two Simulink models on two seperate computers. I would like to run both through one computer, is there a way to do this? I cannot change the transport layer as it is used to communicate with haptic devices.

So my question is, is there a way in MATLAB or Simulink where I can open, connect to target and run a Simulink diagram on another computer.

Thanks in advance!
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top