Sunil Indalkar
Mechanical
Hi, For SA 516 Gr.70 5 Mm thk Plate, I have done forming of Dish end and In approved Drg Post Forming Given at 15 Min minimum holding time, so for how much maximum Holding time we will do PFHT
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Regarding Post Forming of Heat Treatment
- Thread starter Sunil Indalkar
- Start date
- Status
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question