Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Regard minimum Ecentricity

Status
Not open for further replies.
tanvir00

tanvir00

Civil/Environmental
Joined
May 3, 2012
Messages
2
When should i consider minimum ecentricity in column design and when can i avoid it.
 
Sort by date Sort by votes
Always need to consider it. More so a general question than an ETAB's question. I would like to reduce it somewhat so I can make the columns skinner but unfortunatley I have found no justification to avoid it.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Robert-32
  • Locked
  • Question Question
CSI Column Minimum Rebar Percentage
Replies
0
Views
236
Robert-32
Robert-32
Ruchadaphon
  • Locked
  • Question Question
What criteria did ETABS used, whether to use Non-sway Moment or Minimum Moment as the Design Moment
Replies
0
Views
546
Ruchadaphon
Ruchadaphon
Jimmy rosto
  • Locked
  • Question Question
Regarding ETABS modelling and renaming joints.
Replies
0
Views
661
Jimmy rosto
Jimmy rosto
LinhLe
  • Locked
  • Question Question
Silly question regarding instability in ETABS
Replies
8
Views
1K
EZBuilding
EZBuilding
PSR_1
  • Locked
  • Question Question
COMMENT ON CSI ETABS [OTHER PROGRAMS TOO] REGARDING EUROCODE 8
Replies
0
Views
254
PSR_1
PSR_1

Part and Inventory Search

Sponsor

Back
Top