Mech_Guy_98
Mechanical
- Feb 3, 2023
- 25
Hello
Actually we require a concentric reducer for a piping connection with unstandard thickness made with forging material.
What we have done for this is we calculated the bigger end & smaller end connection pipe calculation & ensured the strength of reducer.
But AI was not accepting this calculation of reducer as it is a unstandard size (i.e. apart from the thickness provided in B36.10)
So, AI is requesting to provide the FEA report for the reducer.
Anyone please guide me in performing the FEA analysis?
My doubt in FEA is how to provide the thermal load for the reducer & the boundary condition required.
If any document related to this may helps a lot.
Thanks in advanvce
Actually we require a concentric reducer for a piping connection with unstandard thickness made with forging material.
What we have done for this is we calculated the bigger end & smaller end connection pipe calculation & ensured the strength of reducer.
But AI was not accepting this calculation of reducer as it is a unstandard size (i.e. apart from the thickness provided in B36.10)
So, AI is requesting to provide the FEA report for the reducer.
Anyone please guide me in performing the FEA analysis?
My doubt in FEA is how to provide the thermal load for the reducer & the boundary condition required.
If any document related to this may helps a lot.
Thanks in advanvce