MI95SHO
Mechanical
- Dec 20, 2012
- 35
Hello,
I have a main view used in Drafting (drawing) that was custom oriented to the equipment and not the die draw of the part. It appears at some point all the original guides were removed from the model that created that view.
Is there any way to easily re-create the axis/lines from a view in drafting to the 3D?
Thank you in advance.
--
Design Engineer
NX 11.0
CATIA V5 R26
I have a main view used in Drafting (drawing) that was custom oriented to the equipment and not the die draw of the part. It appears at some point all the original guides were removed from the model that created that view.
Is there any way to easily re-create the axis/lines from a view in drafting to the 3D?
Thank you in advance.
--
Design Engineer
NX 11.0
CATIA V5 R26