Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Received DXF files from from NX3, translation to WF2 flakey

Status
Not open for further replies.

texaspete

Mechanical
Joined
Nov 11, 2002
Messages
120
Location
US
Hi gang, I have a customer that has sent me a DXF file from UG NX3. The contents of the DXF is there drawing formats. When I translate the DXF into WF2 the wire frame looks ok but the text in some areas are good, but in other areas the texts repeats itself - no more than doubles itself. The GD&T, I expected it to weird out. Can anyone direct me to improve translation on WF2 side or what I need to tell the UG NX3 person what to select or make in there setting file.
Thanks in advance - Texaspete
 
You might ask them to export CGM. I've had good luck importing drawings in the past. (It might be necessary to 'roll back' to NX2(?) if that's possible. I have a vague memory of developing mid-project communication problems stemming from their upgrading to NX3. I was using an early WF2 build.)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top