G
George Tekbas
Guest
As a beginner with SolidWorks, I am doing some tutorials. At this moment I'm working on the following tutorial: How to create 17 inch car wheel
At step 4 I experience during "cut-extrude" the following problem and message: "Rebuild errors: the extrude featue could not be created by this sketch Please Check That the skectch extends past the body limits."
Have made several attempts to redraw the sketch and also to make the sketch closing; but every time I get the same message.
Does anyone know what's going wrong and how I can fix this and prevent this to happen the next time.
Thanks in advance!
At step 4 I experience during "cut-extrude" the following problem and message: "Rebuild errors: the extrude featue could not be created by this sketch Please Check That the skectch extends past the body limits."
Have made several attempts to redraw the sketch and also to make the sketch closing; but every time I get the same message.
Does anyone know what's going wrong and how I can fix this and prevent this to happen the next time.
Thanks in advance!
