I'm having a great time trying to read and write to the RS232 port on my Fanuc RH controller. I'm trying to send ASCII files back and forth to my PC. I'm sure I have the cable and port specs right because I can redirect the console output through the port and it works fine. I think I'm formatting the WRITE, READ and OPEN statements incorrectly. Any sample WRITE, READ and OPEN statements would help.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
reading and writing to Fanuc's RS232 port
- Thread starter BobM3
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Article