Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Re: Interface Pressure

Status
Not open for further replies.
Pandya007

Pandya007

Mechanical
Joined
Apr 28, 2016
Messages
1
Location
IN
Hello everyone!
I need help
I am confused to put value of interface pressure po and pt for tube to tubsheet joint (expanded)
What would be the minimum values that i have to consider ?

Regards,
Prathmesh Pandya
 
Status
Not open for further replies.

Similar threads

Amr Shams
  • Locked
  • Question Question
UW-21 minimum requirement for External weld for SO Flange
Replies
2
Views
926
Amr Shams
Amr Shams
ElCidCampeador
  • Locked
  • Question Question
Compress Pressure stress intensity factor from Division 2
Replies
0
Views
207
ElCidCampeador
ElCidCampeador
AWDMIKE
  • Locked
  • Question Question
Simple Cylinder with Nozzle Indicating a Zero Design Pressure
Replies
1
Views
273
AWDMIKE
AWDMIKE
csk62
  • Locked
  • Question Question
Pressure Stress Intensity, I, in WRC 107/537 Analysis
Replies
0
Views
277
csk62
csk62
tngu
  • Locked
  • Question Question
Compress and WRC 537 - square / rectangular attachment
Replies
0
Views
285
tngu
tngu

Part and Inventory Search

Sponsor

Back
Top