Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Rate of Rise technique for measuring pressure drop

Status
Not open for further replies.

MaxPlanck

Chemical
Joined
Jan 2, 2006
Messages
25
Location
BE
Dear all,

I came across information from our honeycomb-supplier and didn't understand a technique he is using.
He measured the pressure drop over the honeycomb material, expressed in seconds. The only information I have, is that it is measured with a "rate of rise" tube and the supplier specified only the height of the honeycomb material (e.g. 200mm) and as said before, the pressure drop expressed in seconds.
When I try to find information on this topic, I cannont find information on this topic for measuring pressure drop.

I hope someone on this forum can help me with this problem.

Many thanks in advance.
Best regards,
Sherpa
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top