Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Radiused wall LISP request

Thread starter smcadman
Start date Sep 10, 2003

Status: Not open for further replies.

Sep 10, 2003

smcadman

Mechanical

I have seen a routine that turns a pline into a wall by offsetting it a requested distance, connects the ends, then extrudes it a set distance. I am looking for a routine similar to this except you select an arc. Any help would be appreciated.

Flores