Mike Brosseau
Mechanical
In NX9, how do you create a radius dimension where the dimension line originates at the centerpoint of the radius? In previous versions, we had Radius to Center dimension. Now, I cannot see how to do this.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
radius dimensioning
- Thread starter Mike Brosseau
- Start date
- Status
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question