radius compensation on cincinnati milacron 1

[pitted]

i have a cincinnati milacron turning centre, hawk 150
with A-2100 contoller. When using radius compensation i can use any offset up to 0.4, but anything after that eg0.8/1.2) it seems that the machine does not except theses offsets.

has anyone experienced this problem, is it a machine parameter that can be set or changed?

cheers

 

[BobM3]

If no one here can help you try the forum at

http://www.practicalmachinist.com/ubb/ultimatebb.php/forum/13.html

 

[pitted]

cheers bob

i've registered on that site, unfortunately i have to wait for administration to sort me out before i can enter any forum. looks like it could be very helpful.

thanks mate