Radial menu selection gestures

[Ron Frack]

Hello, I'm currently using NX11 and recently had my OS updated to windows 10. I'm having an issue with my radial menus where after the menu pops up I have to hover directly over a command/function to get it to start, where as before the update I could move my mouse in the general direction of the command on the menu I wanted and it would start.

 

[NutAce]

Sounds like a graphics driver issue.
Try this (I always do this), you know the positions of the Icon's by head?
You don't have to wait until the radial pops up. Just moving your cursor in the corresponding direction will already activate the icon. (see attached movie)



Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11

 

[NutAce]

Attaching the file in edit mode doesn't seem to work. Therefor....



Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2

Building new PLM environment from Scratch using NX12 / TC11