i'm trying to mate a rack and spur gear that was designed using the engineering references in solid edge v20. the problem is when i try to mate the spur to the rack using the gear relationship (rotational to translational) the spur turns yellow in colour but when the cursor hovers over any outline it does not change to red which allows one to select an edge, axis etc. any suggestions?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
rack and spur mate solid edge v20
- Thread starter mckenna79
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question