Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

"Type W"

Status
Not open for further replies.
soupy1957

soupy1957

Mechanical
Nov 23, 2005
23
What's "Type W" when referring to a Trilobular Thread? (M4x0.7 - 6H Typ W)


Telepathy only enhances the world I live in!!
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Never heard of that before. If you are sure it is Type W, and you are sure it is trilobular, I would contact Reminc (inventors of Taptite trilobular screws).


Regards,

Cory

Please see FAQ731-376 for tips on how to make the best use of Eng-Tips Fora.
 
Upvote 0 Downvote
Probably Wide thread spacing
for plastic threads.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Adz123
  • Locked
  • Question
Design Ideas for a "Fused" Solution 2
Replies
10
Views
464
MintJulep
M
just_some_shmuck
  • Locked
  • Question
Drawing material callout: "material XYZ or Eq." 6
2
Replies
20
Views
905
Christine74
Christine74
Joel_Lapointe
  • Locked
  • Question
Signed von Mises stress when the sign is "zero"
Replies
3
Views
587
centondollar
centondollar
ASIT859
  • Locked
  • Question
"Automatic" Speed control of Air Motor
Replies
0
Views
234
ASIT859
ASIT859
M
  • Question
What type of mechanism does this amusement ride use?
Replies
3
Views
2K
SwinnyGG
SwinnyGG

Part and Inventory Search

Sponsor

Back
Top Bottom