After post weld heat treatment during piping replacement, I noticed small rounded indications in the PWHT areas adjacent to the welds. Others are calling these "Pock Marks" and have them removed by light grinding. What is the proper terminology and what causes this.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
" Pock Marks on Pipe
- Thread starter ISDQAQC
- Start date
- Status
Similar threads
- Question
