Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

"k" value

Status
Not open for further replies.
APH

APH

Mechanical
Sep 7, 2004
79
What is the "K" value ( friction factor) on thread forming screw on plastic woule be. This K is for Torque = K X nominal diameter of screw X clamping force.

I would imagine that it would be higher than 1.

Anyone?
APH
 
Status
Not open for further replies.

Similar threads

Shuno
  • Locked
  • Question
I need to know the acceptable leaka
Replies
0
Views
340
Shuno
Shuno
NAZ1234
  • Locked
  • Question
EN1092-1 FLANGE TAP DRILLING 3/4" NPT
Replies
1
Views
157
comkis
comkis
Powlu
  • Locked
  • Question
Meaning of KB,KST in cylinder.
Replies
0
Views
166
Powlu
Powlu
eduardoeh
  • Locked
  • Question
FLANGE ISOLATING GASKET KITS
Replies
1
Views
183
SJones
SJones
CamoColton
  • Locked
  • Question
Where to find a list of all "CRW5" SKF Radial Shaft Seals? 1
Replies
2
Views
164
smellyseal
smellyseal

Part and Inventory Search

Sponsor

Back
Top Bottom