Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

"Error in reading RSe segment streamer"

Status
Not open for further replies.

Solidox

Industrial
Nov 5, 2002
1
CA
I am trying to load an .ipt file which was made in inventor 5.3 and now I am trying to load it on the machine I have at home, which has inventor 5.0.

Its very important that I sort this out, so if you have any information that would help me out then by all means reply.
 
Replies continue below

Recommended for you

I had the same problem, when we went from inventor 5.3 to 6.0. I looked into this and you can't open a file with a older virsion that was saved in a newer virsion, and you can't save it as an older virsion eather. You needed to have inventor 5.3 on your home machine.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top