Say you have done a linear static unit load and wish to output contours of some linear varying metric like strain at a multitude of loads. A quick way would be to just derive a result by multiplying the unit load's results by a scalar. In Hyperview you can do this very easy through "derived results", but I can't figure out how to do this in FEMAP. Any help?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!