Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

"BEND on element xxx to xxx not properly specified"

Status
Not open for further replies.
treemkr

treemkr

Mechanical
Joined
Oct 3, 2006
Messages
18
Location
US
I have a model where I entered an element and indicated a bend. I then went back and inserted a branch element at a previous tee location. When I go back to the first element and continue the model does not show a bend at the intersection and when the model is run reports the error in the subject line, which continues:
"The following element should define the DOWNSTREAM side of the bend".

How do I recover from this without rebuilding the model?
 
Status
Not open for further replies.

Similar threads

dozer
  • Question Question
How to model 105 degree elbow?
Replies
2
Views
2K
dozer
dozer
jseag
  • Question Question
When to utilize Caesar's liberal stress allowables?
Replies
3
Views
7K
StressGuy
StressGuy
TomoB
  • Locked
  • Question Question
Modeling fittings acc. to ASME B16.11
Replies
2
Views
2K
TomoB
TomoB
TG004
  • Locked
  • Question Question
What is the recommended method to m
Replies
0
Views
1K
TG004
TG004
madl_07
  • Locked
  • Question Question
ASME B31.1 Weld Joint Efficiency, why is Caesar II dividing the weld eff to stress allowable?
Replies
0
Views
987
madl_07
madl_07

Part and Inventory Search

Sponsor

Back
Top