dears engineeres I just got the document from our vendor, I asked to check the calculation for example hub verification, and they gave me a simple calculation without any detailed calculation, only a result. Please, if anyone can help me with this calculation, send me some documents that I can refer to.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Quick opening closuer for pig trap? 1
- Thread starter J.I.h
- Start date
-
1
- #2
GBTorpenhow
Mechanical
What design code was the closure specified as conforming to? I'm used to seeing either ASME B31.8 or ASME BPVC Section VIII for these, but other design codes may govern. Whatever design code was specified will have the calculations you are looking for.
- Thread starter
- #4
- Status
Similar threads
- Question
- Locked
- Question
