Hi
I have a question about how update is triggered.
exmpl no.1:
A single part named "def.prt" containing a datum csys and a datumplane placed 100mm at distance in X direction (or other geo)
this datum is copied via "WAVE" > "Copy to Geometry to Part" to another part named "geo.prt".
When I edited the datumplane in "def.prt" , and then go back to my "geo.prt" , I need to "Update for external Change",before my datum is updated to a new distance.
Is that working as desigend ?
exmpl no.2: If I apply the above 2 parts in a assembly - same level ,the datumplane is updated immediately when edited in the "def.prt" .
Should "def.prt"+"def.prt" part be put in an assembly, if immediately update is wanted ?
lklo
I have a question about how update is triggered.
exmpl no.1:
A single part named "def.prt" containing a datum csys and a datumplane placed 100mm at distance in X direction (or other geo)
this datum is copied via "WAVE" > "Copy to Geometry to Part" to another part named "geo.prt".
When I edited the datumplane in "def.prt" , and then go back to my "geo.prt" , I need to "Update for external Change",before my datum is updated to a new distance.
Is that working as desigend ?
exmpl no.2: If I apply the above 2 parts in a assembly - same level ,the datumplane is updated immediately when edited in the "def.prt" .
Should "def.prt"+"def.prt" part be put in an assembly, if immediately update is wanted ?
lklo