Query about Nx wall thickness check. 3

[ssram143]

I have couple of query about Nx wall thickness check command.

1.

2.

I have uploaded the NX part file which i have used for wall thickness analysis.

http://files.engineering.com/getfile.aspx?folder=17a43793-273b-4ecc-8e7f-3db9ed2dbee6&file=test.prt

Requesting you to go through above queries and let me know your valuable comments.


Thanks in advance,


Regards,
Sreeram

 

[petulf]

Hi I would suggest reading the documentation for the wall thickness tool.

1)
* Modeling tolerance will not have any noticeable effect on the wall thickness tool.
* The radii deviation is due to tesselation difference between the surfaces, this become evident if you use a finer tolerance, rolling ball spacing, and adjust color fringes, see image below.

In comparison thickness calculated in GOM Inspect Pro

2) Read the documentation of how rolling ball works

 

[ssram143]

Hi Petulf,

Thank you for your prompt reply ))

The pictures which you have attached is not visible for me.
Could you upload it again?


Thanks,
Sreeram

 

[petulf]

Ok, they are hosted on

http://i.imgur.com

but i have attached them in a zip file to this post.

 

[ssram143]

Thank you very much petulf