Apr 3, 2012 #1 aszepesi Mechanical May 26, 2010 81 I have got the following message when I try to create a new IR on the QTAC site. Any idea?
Apr 3, 2012 #2 Arkance/PhoeNX Mechanical Mar 2, 2010 869 I had the same thing happen to me yesterday. Try http://webtac.industrysoftware.automation.siemens.com/logir_legacy/ instead which works, just doesn't look as nice. Anthony Galante Technical Resource Coordinator NX4.0.4MP10, NX5.0.6, NX6.0.5, NX7.0.1, NX7.5.0-> NX7.5.5 & NX8.0.0 -> NX8.0.1 Upvote 0 Downvote
I had the same thing happen to me yesterday. Try http://webtac.industrysoftware.automation.siemens.com/logir_legacy/ instead which works, just doesn't look as nice. Anthony Galante Technical Resource Coordinator NX4.0.4MP10, NX5.0.6, NX6.0.5, NX7.0.1, NX7.5.0-> NX7.5.5 & NX8.0.0 -> NX8.0.1
Apr 3, 2012 Thread starter #3 aszepesi Mechanical May 26, 2010 81 Thanks Anthony. I did it with this link. Attila Szepesi support engineer graphIT Ltd. http://www.graphit.hu Upvote 0 Downvote
Thanks Anthony. I did it with this link. Attila Szepesi support engineer graphIT Ltd. http://www.graphit.hu
