diverblue
Mechanical
- Jul 6, 2010
- 19
Hi
I am building a script for a composite laminate but have run into difficulties trying to seed edges with bias properly on each ply. I have the edge seeded by number = 40 with a single bias = 10. The script works at seeding the edges of interest but I can't get the bias to point in a common direction for each edge on every ply through the stack without manually correcting the direction in the GUI. Is there script which can assign a direction to the bias?
Cheers
RD
I am building a script for a composite laminate but have run into difficulties trying to seed edges with bias properly on each ply. I have the edge seeded by number = 40 with a single bias = 10. The script works at seeding the edges of interest but I can't get the bias to point in a common direction for each edge on every ply through the stack without manually correcting the direction in the GUI. Is there script which can assign a direction to the bias?
Cheers
RD