I am in a debate with a colleague regarding the PWHT for partial penetration tube to header welds. Code of construction is ASME Section 1 (Table-PW-39-4) Header is SA-335-P22 (P5A) 14" Sch 160 1.406" tube material is SA-213-T22 2" x 0.165" (P5A) Tube is inserted into a machined "J" type groove with a depth of 0.250" completed weld will be a 0.-375" fillet weld. General Notes (a)(1)(b) a nominal base metal thickness of 5/8" or less at the weld. it is my take on this is PWHT is not required as long as all the other requirements are met. Please advise.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
PWHT Partial Penetration Fillet Welds 1
- Thread starter GemmellG
- Start date
-
1
- #2
PWHT is required. When you review the Notes in Table PW-39-4, the nominal base metal thickness of 5/8 in. (16 mm) or less at the weld. The base metal thickness of the header which is one of the base metals of the weld exceeds 5/8" therefore, you shall PWHT.
- Status
Similar threads
- Question
- Question
