pushover analysis in SAP2000

[sepehriii]

hi I'm modeling a building in SAP2000 for pushover analysis after I ran the model in display menu-> pushover curves I can see the pushover curve based on FEMA-356 but when i want to see the table of it there is only two columns (steps&displacement) there should have been AtoB BtoO and....why it doesn't show that? please help me...

 

[JasonMcKee71]

Did you assign the data of the response spectrum?

Jason McKee
proud R&D Manager of
Cross Section Analysis & Design
Software for the structural design of cross sections
Moment Curvature Analysis
Interaction Diagrams
Reifnorcement Design etc.