PUSHOVER ANALYSIS by STATC GENERAL (URGENT)

[daniel8892]

Hi, I am currently running a pushover analysis using static general with displacement of 65mm and various axial load as my project is about the effect of axial load in the column by performing pushover analysis. I have tried so many times since past 6 weeks and searched for solution including this forum. Yet I am still not able to solve as I am new to ABAQUS and do not really understand. I know the issue is happen on the time increment as I keep on getting the same error such as too many attempt made for this increment and etc. Is it possible to tell me what I should do ?

Thank you and appreciate

 

[missil3]

If you post the error you are getting, someone here can help you out.

 

[rb1957]

"my project" ... work or school ?

either way, is there no-one there who can help ?

have you read the manual ? run the example problems ? asked the help desk ?