Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

punch file output

Status
Not open for further replies.
salconte

salconte

New member
Joined
Oct 11, 2011
Messages
2
Location
DE
Hi,

Is there any possibility to request in the punch file the displacements in global coordinate system and not in the analysis coordibnate system?

thanks in advance
 
Sort by date Sort by votes
Nastran solution is essentially a program written in DMAP language, which is described in "DMAP Programmer’s Guide" . You may write a short Dmap Alter , place it in the executive control and run it.

regards
 
Upvote 0 Downvote
thanks for your reply.
is there any DMAP Alter available online?

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

LWat
  • Locked
  • Question Question
Freq Response (Sol111) - output file size
Replies
3
Views
851
dmapguru
dmapguru
S
  • Question Question
Changing Nastran .f06 file Format
Replies
2
Views
2K
rb1957
rb1957
A
  • Question Question
can we output Topology Optimization Element Density Distribution in the op2 itself
Replies
0
Views
2K
abhishek33
A
jmarkus
  • Locked
  • Question Question
NASTRAN SOL 106 in SimCenter 3D - Shell Thickness Output?
Replies
7
Views
923
sdm919
sdm919
stefanix1972
  • Locked
  • Question Question
MONPNT3 output in pch rather than in f06
Replies
5
Views
780
stefanix1972
stefanix1972

Part and Inventory Search

Sponsor

Back
Top