I have an old Modicon 84 along with the P370 controller. I was wondering if anyone knew how to pull the code off that is being run on the Modicon 84. I plugged in the P370 controller but nothing seemed to happen. I have limited knowledge of PLC's so if anyone has any suggestions I would greatly appriectaite it.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Pulling Code from Modicon 84
- Thread starter phill92
- Start date
modiconbob
Electrical
To download the program from a Micro 84, you will need the P370 plus a P371 program pack. Depending upon the memory size you would need a 001 or a 002 (iK or 2K).
Bob
Bob
- Status
Similar threads
- Locked
- Question
- Locked
- Question