Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Proper O'ring Straight Thread Boss SAE J514 vs. MS33649

Status
Not open for further replies.
johnSchwaner

johnSchwaner

Aerospace
Jan 15, 2007
41
Is there any difference in the boss o'ring used for a straight thread boss SAEJ514 and a MS3649 (formerly AND10050)?

While I'm asking - what is the difference between a SAEJ514 and MS3649?


 
Status
Not open for further replies.

Similar threads

StressGuy
  • Question
Straight run for vertical pump suction piping?
Replies
5
Views
4K
StressGuy
StressGuy
mariolucas75
  • Question
Flange magnetic properties outside vs inside
Replies
7
Views
3K
hacksaw
hacksaw
monang77
  • Locked
  • Question
Leak thread through control line
Replies
1
Views
2K
A8yssUK
A8yssUK
IanVG
  • Locked
  • Question
Calculation or Design Guidelines for Proper Sizing of Flexible Floating Ball Extractor
Replies
2
Views
1K
LittleInch
LittleInch
T
  • Solved
Pressure drop vs volumetric flowrate 1
Replies
11
Views
3K
Snickster
Snickster

Part and Inventory Search

Sponsor

Back
Top Bottom