my pc crashed and once we reinstalled everything the settings on my pronest were restored to default, when trying to send a job to the plasma cutter the error on the pc reads: file does not exist and the control unit reads: program not found any suggestions on what to do next?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Pronest / caliburn control unit
- Thread starter rene02
- Start date
My experience with MTC/Pronest is that any questions like this require a call to tech support. Isn't much we could troubleshoot on our end without their assistance. They basically take control of your Pronest workstation via webex and reconfigure some settings.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
