Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ProE crashes when creating xhatched view

  • Thread starter Thread starter skraba
  • Start date Start date
Status
Not open for further replies.
S

skraba

Guest
Hello!



Has anyone experienced problem with Pro/E crashing everytime when creating xhatched partial view?



I'm using Pro/E 2001 build code 2002350 and tried to create partial view. So far so good. But when I tried to change this view to xhatched view (full x- and planar section) Pro/E crashes and 'std.err' contains message RAISING SIGNAL : Signal number : 11.



Anyone, help?



Best regards,

Jurij Skraba
 
Status
Not open for further replies.

Similar threads

Lion_Engineer
  • Locked
  • Question Question
Creating negative impression of another model?
Replies
8
Views
936
Lion_Engineer
Lion_Engineer
M
Create a part or view
Replies
1
Views
2K
msiva1981
M
M
Custom Cross sections in Creo View
Replies
0
Views
2K
msiva1981
M
samim09me
  • Locked
  • Question Question
Why this ProE Conflicts dialog box appears?
Replies
1
Views
400
3DDave
3DDave
vorst
  • Locked
  • Question Question
Creo 4 crashes when opening a part
Replies
6
Views
1K
dgallup
dgallup

Part and Inventory Search

Sponsor

Back
Top