Produce an excel report from a BOM

[ProEDesigner00]

Ladies and Gentlemen

Is there away to produce an excel file from an assembly BOM information?

I know you can produce a txt file then copy paste. I want to skip that step.

I am running WF3.

Thanks

 

[ProEDesigner00]

ok we saved the file as a TXT then in excel was able to open that TXT file up............... Can I give myself a star?

 

[cadcamguy]

hey did you get the mapkey running right from before?

 

[cadcamguy]

u might like to check this out too

 

[cadcamguy]

duh....lol

http://www.ptc.com/go/wildfire/learn/drawing_tables/index5.htm

 

[Hora]

A full BOM table from an assembly, without using the drawings, which calculates the mass properties no matter if the parameters are assigned to the components can be done only in ProToolkit.


-Hora

 

[ProEDesigner00]

Thanks guys.

Cadcamguy.........not as well as I wanted to. I imported a neu file and got rid of the few paramters not needed in each part.

I have figured out how my sawdust furnace should work and am creating some amazing heat using wet sawdust. Actually you can burn any bio fuel in it as long as its has some moisture. and its naturally aspirated! I have an order for 10 of them.

Next project is to finish the design of and build a small cnc mill. Motors were bought today.