Problems with full vehicle analysis

[Gursafal]

Hi everyone,
I am new to ADAMS, I am trying to do a full vehicle analysis for my mini baja buggy. I have created the front and rear suspension templates by myself. I also tested these by performing suspension analysis on them. When I tried doing a full vehicle analysis I get an error message which says that the largest error was in model.testrig.sse.diff1. So, I thought the problem was with my templates and created a new vehicle assembly from the subsystems provided with the software I still got the same error. But, when I opened the full vehicle assemblies provided with the software and performed analysis on it, I got no error. I hope someone can help me out with this.
thank you.

 

[GregLocock]

You might get more relevant response from

https://www.reddit.com/r/FSAE/

As it is there is not enough to go on, as I do not willingly use /Car. I suppose you could try starting from thr model that works and then swapping in your subsystems until it breaks.

Cheers

Greg Locock


New here? Try reading these, they might help FAQ731-376

http://eng-tips.com/market.cfm?