Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Problem with 2 Separate Meshes in CFX!

Thread starter richonlinedeal
Start date Aug 18, 2007

Status: Not open for further replies.

Aug 18, 2007

richonlinedeal

Mechanical

Hello, Deal all,

I have a CAD model with two components which share the same interface but have separate meshes. After I import the two meshes into CFX, how should I define the interface? Should I choose the Turbomachinery or General type of simulation? I tried to define the interface as Frozen Rotor for steady state simulation, but it didn't run. I guess I missed something, hope some expert here can give me some clue. BTW, the flow passes the interface.

Thanks a lot.

Jerry