Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Problem doing VGLUE

Thread starter brunoserrano
Start date Apr 29, 2009

Status: Not open for further replies.

Apr 29, 2009

brunoserrano

New member

Hi,

I am modeling fatigue circular crack evolution on ANSYS but I have a problem in the geometry. For some values of crack dimension the VGLUE is done without any problem but for other values it gives me an error asking to change BTOL? It's purley randomic. The geometri was done in ANSYS.

1. Does anyone know another away to glue volumes?

2. If not. Does anyone know how to use correcty BTOL?

Thanks a lot!