I am looking for anyone who has used NC Sheetmetal, the Pro/E module for programming turrets or lasers. On the surface, it sounds like a good idea to design & manufacture in the same software package. But does it work? Thanks in advance for any comments, positive or negative.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Pro/E NC Sheetmetal
- Thread starter meterbox
- Start date
Similar threads
- Locked
- Helpful tip
- Locked
- Question
- Locked
- Question