T
teslamusas2
Guest
Hello everyone,
Sorry if this has already been addressed, but I couldn't find anything.
Whenever I add a new part to an assembly, the BOM table doesn't show the addition of the new part. Whenever I add balloons to the drawing, Pro/E adds balloons for all of the parts except for the newly added part.
I've deleted and added the bom table several times, with no change. Whenever I try to add a balloon specifically on the omitted part, I cannot, probably because part is not showing up in the BOM table.
All the tutorials I can find indicate that changes like this should be updated automatically. I've tried the "update the display of all views on the active sheet" button (little yin-yang arrows), but it has had no change.
Currently using Wildfire 3.0 (old, I know).
It's probably a simple button I haven't yet learned to press. The nut on my keyboard probably needs a little adjustment.
Any advice is appreciated!
Sorry if this has already been addressed, but I couldn't find anything.
Whenever I add a new part to an assembly, the BOM table doesn't show the addition of the new part. Whenever I add balloons to the drawing, Pro/E adds balloons for all of the parts except for the newly added part.
I've deleted and added the bom table several times, with no change. Whenever I try to add a balloon specifically on the omitted part, I cannot, probably because part is not showing up in the BOM table.
All the tutorials I can find indicate that changes like this should be updated automatically. I've tried the "update the display of all views on the active sheet" button (little yin-yang arrows), but it has had no change.
Currently using Wildfire 3.0 (old, I know).
It's probably a simple button I haven't yet learned to press. The nut on my keyboard probably needs a little adjustment.
Any advice is appreciated!
