Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pro/E 2001 and Ansys Mechanical 7.0

  • Thread starter Thread starter Freecat
  • Start date Start date
Status
Not open for further replies.
F

Freecat

Guest
Can anyone comment on how Ansys Mechanical 7.0 is used in conjunction with Pro/E 2001? More specifically, what are the best ways to use Ansys with Pro. I am new to FEA and am trying to understand how Ansys is integrated to work with Pro, in a way that lets you have full associativity between the Pro/E model, and the Ansys model.
 
Go to

D:\ANSYS7\v70\ANSYS\bin\intel\ANS_ADMIN

and configure ANSYS for Pro Engineer 2001. After this you can invoke ANSYS form Pro/Engineer 2001 session but only in part mode. For Assembly mode tranfer ANSYS DesignSpace 7.0 is best.



Israr
 
Status
Not open for further replies.

Similar threads

jasongBSME
  • Locked
  • Question Question
Converting from Pro/Mechanica to Creo Simulate
Replies
0
Views
801
jasongBSME
jasongBSME
woofer54
  • Locked
  • Question Question
Pro E Wildfire 5.0 Mechanism Flexible Simulation
Replies
0
Views
705
woofer54
woofer54
T
Pro mechanica - create a mesh from imported points (nodes)
Replies
1
Views
24K
Twig Studio
T
kdaenerys
  • Locked
  • Question Question
Drive Creo Simulate through Microsoft Excel
Replies
1
Views
1K
kayla_engineer
kayla_engineer
A
Pro/Mechanica Material Assignment and Meshing for Assemblies
Replies
0
Views
6K
AMega
A

Part and Inventory Search

Sponsor

Back
Top