Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pressure Vessel or Large Pipe Modeling

Status
Not open for further replies.
GSigma

GSigma

Structural
Joined
Oct 18, 2011
Messages
9
Location
US
I have a 120" pipe that I would like to check the stresses at the support points. However, I do not know how to simulate the weight of water in the pipe.

I am using STAAD

Any tips would be greatly appreciated.

Thank you,

 
Status
Not open for further replies.

Similar threads

M
  • Question Question
FEA Adhesive Modeling
Replies
3
Views
5K
milio000
M
EdwardNigma
  • Locked
  • Question Question
Mastering FEA: How to Get Through Stage 2 (Developing Good Modeling Techniques)?
Replies
7
Views
4K
rb1957
rb1957
BioMes
  • Locked
  • Question Question
3-2-1 method for cylindrical pressure vessel
2
Replies
36
Views
3K
karachun
karachun
oharag11
  • Locked
  • Question Question
Modeling/simulating thermal vias - PCB/Electonic thermal analysis?
Replies
0
Views
733
oharag11
oharag11
vanji1
  • Locked
  • Question Question
If I want to construct myself a geometric stiffness matrix induced by a pre constraint with finite element modeling
Replies
0
Views
1K
vanji1
vanji1

Part and Inventory Search

Sponsor

Back
Top