Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pressure used for nozzle thickness and reinforcement calculation.

Status
Not open for further replies.

Arsan16

Mechanical
Joined
Mar 6, 2019
Messages
3
Location
AE
We have a vessel having internal coil with higher design pressure than that of vessel. For calculating the coil inlet and outlet nozzle thickness and reinforcement do we have to consider the design pressure of coil which is higher?
 
Yes, and it is relatively easy, however current available software doesn't handle this scenario, therefore you will need to do it by hand.
 
Hi DriveMeNuts .. Thanks for the response... I think we can run the calculation separately for these nozzles with a user defined MAWP value same as the coil design pressure..
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top