Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Pressure part.

Status
Not open for further replies.
HOYA

HOYA

Mechanical
Joined
Jul 5, 2009
Messages
5
Location
KR

I can see many times following sentence in project spec.
"Pipe used for pressure containing components shall be seamless"

Can I regard "pressure containing components" as " pressure part"? Please advise.

Thank you.
 
Sort by date Sort by votes
Status
Not open for further replies.

Similar threads

Virendra Patel
  • Locked
  • Question Question
Replacement of same pressure vessel part (HX bonnet) needs only R-1 report.
Replies
2
Views
478
rachnatbovo
rachnatbovo
S
  • Locked
  • Question Question
Inquiry about pressure vessels
Replies
3
Views
4K
TomLee777
TomLee777
K
  • Question Question
Calibration of low Pressure - Vacuum Relief valves
Replies
0
Views
932
Kibar Anderson
K
E
  • Locked
  • Question Question
Thin Walled Pressure Vessel
Replies
4
Views
2K
TGS4
TGS4
teokal
  • Locked
  • Question Question
Saddle calculations for ASME VIII Div.2 Pressure Vessel - paragraph 4.15
Replies
0
Views
2K
teokal
teokal

Part and Inventory Search

Sponsor

Back
Top