Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Pressure contact on shaft/hub coupling
- Thread starter dimi81
- Start date
dimi81
Since you are concerned about the contact pressure at the joint, the hub must not be sliding along the hex. The coupling is more than likely at the end of the shaft so why not make it easy for yourself and turn the hex to the diameter across flats and add a key? Now everything is "text book".
Since you are concerned about the contact pressure at the joint, the hub must not be sliding along the hex. The coupling is more than likely at the end of the shaft so why not make it easy for yourself and turn the hex to the diameter across flats and add a key? Now everything is "text book".
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Helpful tip
- Locked
- Question