alansimpson
Mechanical
I somehow managed to get my SE to place a hole prefix in all dimensions automatically. I don't know how this happened and can't figure out how to stop it.
Any ideas?
Using SE16
Any ideas?
Using SE16
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Prefix problems
- Thread starter alansimpson
- Start date
- Status
beachcomber
Mechanical
Hi alan,
Click on the dimension command, but before you place a dimension go to prefix and clear the text from the box.
That should do it.
bc
Click on the dimension command, but before you place a dimension go to prefix and clear the text from the box.
That should do it.
bc
Hi,
some additional info:
when dimensioning is active but nothing is selected setting
prefix, suffix a.s.o then all dimensions will take that
setting from now on. This may inadvertedly happen after
placing a dimension and then set a prefix. Everything is
still shown within the toolbars but nothing is selected
anymore.
dy
some additional info:
when dimensioning is active but nothing is selected setting
prefix, suffix a.s.o then all dimensions will take that
setting from now on. This may inadvertedly happen after
placing a dimension and then set a prefix. Everything is
still shown within the toolbars but nothing is selected
anymore.
dy
- Status
Similar threads
- Locked
- Question