Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Preferred coating for spool valve...

Status
Not open for further replies.

quizzical1

Mechanical
Jul 6, 2004
180
US
Hi All,

Just wondering if I could get a few suggestions as to the best coating to reduce / avoid sticking for a 303 SS spool valve (can be another metal if need be).

It will be used in 60 psig hot/cold water mixing with temps ranging from 45F - 70F cold side and 100F - 150F hot side if this matters.

Can anyone recommend a preferred coating that would allow proper operation while minimizing scale build up and not wearing off during valve's expected life (2 yrs)?

Thanks,

Glenn




 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top