Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PQR done with API 5L pipe, Can it be used on ASME Sect. VIII D1 Vessel?

Status
Not open for further replies.
YMech

YMech

Mechanical
Joined
Aug 29, 2017
Messages
22
Location
US
Hello,
I have a PQR done with API 5L Gr. X65 pipe. Can I use this PQR/WPS to weld on an ASME Section VIII, Div. 1 vessel that uses SA-516 70 plate? The P numbers and group numbers are the same for both materials.

Thanks!
 
Sort by date Sort by votes
Were the requirements of ASME Section IX satisfied when the procedure was qualified?
 
Upvote 0 Downvote
PQR was done strictly to ASME IX, satisfying all requirements.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

MchA
  • Question Question
Forming Strains under ASME VIII-1 vs ASME VIII-2
2
Replies
24
Views
13K
David3399
D
Ratheesh_n
  • Question Question
stress reliving on 3mm 625 plate butt weld during PQR qualification for utilising in cladded vessel
Replies
2
Views
11K
Ratheesh_n
Ratheesh_n
Sajjad2164
  • Question Question
ASME VIII-1 Nozzle Spacing Clash
Replies
7
Views
11K
Si-bo
Si-bo
C
  • Question Question
ASME VIII DIV 2 Limit Load Analysis Questions
Replies
2
Views
4K
CMEA
C
SphericalHead
  • Locked
  • Question Question
Courses on ASME VIII Div 2
Replies
5
Views
3K
SphericalHead
SphericalHead

Part and Inventory Search

Sponsor

Back
Top