Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

PP for small injection-molded part

Thread starter cholladay
Start date Feb 29, 2016

Status: Not open for further replies.

Feb 29, 2016

cholladay

Bioengineer

Hi,
I'm trying to source an alternative resin for some small, injection molded parts. Has any one ever used a lumicene polymer? I have no experience with metallocenes so I'm trying to guess if there will be anything unusual about its surface chemistry or anything.
Cheers!