Power screw mechanism in Creo 2.0

[yurilev]

Hello all,
I'm trying to simulate a power screw mechanism in Creo 2.0.
Since "slot and follower" connection was removed in Creo 2, I have no idea how to connect between the point on the nut and the helix (datum curve) on the screw.
That makes me pretty much "scXxXed"
It would be great to get some tips.
Thanks in advance,
Yuri

 

[jay.coker]

hi yurilev,
slot and follower in Creo 2.0 is now applied when you assemble the part (instead of in mechanism), found at the bottom of the mechanisms constraints

 

[design-engine]

upload your models and let us play with them